Nano Chiller for aquariums from 60-80L (depending on ambient temperature etc.)Temperature setting with one key, adjustable temperature range: 15-35 degrees Celsius (℃)This machine can be used for both cooling and heating. Please pay attention to the difference when setting the temperatureBuilt-in high-efficiency energy-saving compressor, support automatic constant temperature function.Operating sound: about 20 decibels, the use of deep-sea noise reduction fan, rotor roller running low decibels, noise is far lower than the compressor cooling chiller, does not affect you and your family’s sleep and entertainment, home of choice.Run the unit with freshwater outside Ur tank for 30min Or longer in order to wash off the oil in the Brand new machine.SpecificationsModel: LG-CH60Power: 200WFrequency: 50HzAquarium Size: Up to 80LRate of Flow: 120-300L/HSize: Approx 160×280×190mmOutlet/Inlet diameter 8mm – included in the package is approx 1.6m of 9mm diameter hosing Approx size of temperature probe: 2M Please ensure enough ventilation is around the unit in order to operate properlyHigh-effect and ECO. Running silent and stable.Do not coverReal-time temperature display and temperature control buttons. Easy operation and convenient fours.Full automatic control by the microcomputer intelligent temperature control system. Intuitive interface and easy operationCompact structure and corrosion resistant by the titanium heat exchanger Suitable for fresh and marine aquarium.Vertical efficient cooling system and high-quality strainer and compressor,. Effective running silently.Indoor use only Place on a flat surfaceAvoid high room temperature & dustKeep approx 20cm from the wallInstructions for use:Basic using (heating or cooling) Short press “set”, and the number will flash, use “↑” or “↓” to set the temperature u want.Advance using (setting up a stable temperature range) For example, i want to set up at 25 ℃, i want the chiller heat up when the temperature goes down to 23 ℃, and cooling down when temperature goes up to 28 ℃ 1: short press ” set” and set up at 25℃ 2: hold “set” for 3 sec or longer, you will see “F0”, then using “↑↓” to choose “F1″(heating), and short press “set”, using “↑↓” to set up at 2 ℃ (25-23=2) 3: hold”set” for 3 sec or longer, you will see “F0”, then using “↑↓” to choose “F2” (cooling)., and short press “set”, using “↑↓” to set up at 3 ℃ (28-25=3)“F0” is the target temperature, same as short press “set” “F3” is recalibrating the chiller. If your own thermometer shows 23, But the chiller shows 24, you need make -1 ℃ on the chiller Hold “set”, choose “F3”, short press “set” and set up -1 ℃Please note hosing and water pump are not included – these will need to be purchased separatley
